djlesno.blogg.se

Refer to the Addressing Table for the IPv6 address. Set the IPv6 Address to 2001:DB8:1:2::3 with a prefix of /64. a.Ĭlick Engineering and then select the Desktop tab followed by IP Configuration. Step 2: Configure IPv6 Addressing on the Engineering and Design Clients.

Set the IPv6 Address to 2001:DB8:1:1::3 with a prefix of /64. a.Ĭlick Billing and then select the Desktop tab followed by IP Configuration. Part 3: Configure IPv6 Addressing on the Clients Step 1: Configure IPv6 addressing on the Sales and Billing Clients. Repeat Steps 1a to 1c for the CAD server. Step 2: Configure IPv6 addressing on the CAD Server. Packet Tracer - Configuring IPv6 Addressing Set the IPv6 Gateway to the link-local address, FE80::1. Set the IPv6 Address to 2001:DB8:1:1::4 with a prefix of /64. a.Ĭlick Accounting and click the Desktop tab > IP Configuration. Part 2: Configure IPv6 Addressing on the Servers Step 1: Configure IPv6 addressing on the Accounting Server. a.Įnter the commands necessary to transition to interface configuration mode for Serial0/0/0.Ĭonfigure the IPv6 address, the link-local and activate the interface. Step 4: Configure IPv6 addressing on Serial0/0/0. Refer to the Addressing Table to obtain the correct IPv6 address.Ĭonfigure the IPv6 address, the link-local address and activate the interface. a.Įnter the commands necessary to transition to interface configuration mode for GigabitEthernet0/1.

Step 3: Configure IPv6 addressing on GigabitEthernet0/1. Press Enter.Įnter the commands necessary to transition to interface configuration mode for GigabitEthernet0/0.Ĭonfigure the IPv6 address with the following command: R1(config-if)# ipv6 address 2001:DB8:1:1::1/64Ĭonfigure the link-local IPv6 address with the following command: R1(config-if)# ipv6 address FE80::1 link-local Step 2: Configure IPv6 addressing on GigabitEthernet0/0. This command will be discussed in a later semester.

This command must be configured to enable the router to forward IPv6 packets. a.Įnter the ipv6 unicast-routing global configuration command. Part 1: Configure IPv6 Addressing on the Router Step 1: Enable the router to forward IPv6 packets. You will also practice verifying your IPv6 addressing implementation. Packet Tracer - Configuring IPv6 Addressing Part 2: Configure IPv6 Addressing on Servers Part 3: Configure IPv6 Addressing on Clients Part 4: Test and Verify Network Connectivityīackground In this activity, you will practice configuring IPv6 addresses on a router, servers, and clients. Objectives Part 1: Configure IPv6 Addressing on the Router Packet Tracer - Configuring IPv6 Addressing (Instructor Version) Instructor Note: Red font color or gray highlights indicate text that appears in the instructor copy only.